Boiler Repairs Enfield (EN1, EN2, EN3), Boiler Breakdown Repair Service in Enfield, No Call-Out Charge, Free Estimates

Month: August 2014

New Tap Seat or O Ring

A constantly dripping tap isnt always fixed just with a new washer, sometimes the valve seat will have some damage. The valve seat concerned is the surface that the washer closes on as the tap is turned off. The water pressure under this washer tries to push itself in between the seat and washer, so that over time the water will wear away the brass seat. Small channels form in the seat and let the water pass between the washer and seat and this is what causes the tap to drip. Hard water areas are more prone to this. Enfield Boiler Repairs use skilled tradesmen. If a tap still drips after you have replaced the washer, the seat is probably worn, still allowing the water to leak past the washer. The easiest way to cure this is to cover the old seat with a nylon liner that is sold with a matching jumper and washer. An Enfield Boiler Repair plumber has the experience to do this job. Once you have the piece, drop the liner over the old seat, and replace the jumper and assemble the tap. Shut the tap to force the liner into position. You could use a tap-grinding tool to make a new smooth surface on the seat. The tool uses serrated cutters to grind out any imperfections that might be allowing the water to pass. Remove the headgear and insert the grinder and screw the threaded bush to the tap to locate the tool securely. Push and twist the grinder clockwise. The resurfacing is finished when the whole seat looks shiny and new. With a mixer tap each valve is usually fitted with a washer, as with conventional taps, but in most mixers the gland packing has been replaced with a rubber O-ring. The base of the mixers swivel spout is also sealed with a washer or O-ring. If water leaks from that, it needs replacing. Firstly, remove the mixer spout, and the retaining screw may be accessible from the front, if it is at the back, you may have to use a cranked screwdriver to remove it. Lift out the swivelling spout, then, use a small screwdriver to flip out the O-ring from its groove. Take care not to scratch the metal. Make sure you always lubricate a new ring with silicon grease, then, carefully slide it into place before refitting the spout and replacing the retaining screw.

Fixtures In Plumbing

The fixture that is known as the plumbing trap?is a curved pipe, and is normally fitted below a plumbing fixture. The trap is a very importnt part of a propertys plumbing for a couple of reasons. Firstly, a trap stops any nasty odours or smells form coming back into a home. Enfield Boiler Repairs are plumbing professionals. The second reason is that a trap also captures items that may cause major clogging or blocks if they progress further into a drain system. Our sewage systems do produce lots of not very nice smells of which some are considered to be quite dangerous. There are quite a few different traps around like these: Straight-Through Trap is a very well designed trap that is made so that the waste pipe runs right into the body of the trap itself. This type can be difficult to gain entry, particularly in emergencies, and are not very flexible like an S-Trap. The Bottle Trap is quite easy on the eye for neatness but is easily clogged. The bottle can also be too wide for installing in a pedestal. It is possible however, to buy something called a mini bottle trap that works fine. There is a height adjustment option that helps if the waste passes out through a wall. The S-Trap is really for pipework coming from floors. Self-Sealing Trap is similar to the S-trap. An Enfield Boiler Repair plumber is a qualified professional. This type keep their watertight seal, and are great for a basin that is left for a long time. It only requires hand tightening, but you can always give it a final ? turn using pump pliers. You must never begin with pliers, as the plastic thread of the trap can be very easily ruined by the brass on the threaded waste pipe.